Adams Electric will own first plug-in hybrid electric utility vehicle (PHEV)

Jan. 1, 2020
Adams Electric Cooperative, headquartered in Gettysburg, Penn., will be the first utility in the United States to own and operate a plug-in hybrid electric vehicle (PHEV) bucket truck.
Untitled Document

Adams Electric Cooperative, headquartered in Gettysburg, Penn., will be the first utility in the United States to own and operate a plug-in hybrid electric vehicle (PHEV) bucket truck.

“To our knowledge,” says Steve Rasmussen, Adams Electric’s CEO/general manager, “no other utility has such a material-handling vehicle. Because final assembly was done in York, Pennsylvania, it also lays the groundwork for a Pennsylvania-based service center for this technology.”

DUECO, Incorporated, in conjunction with ODYNE Corporation (OTCBB:ODYC), the leading developer of advanced plug-in hybrid electric vehicle (PHEV) technology, has developed the PHEV propulsion system for the vehicle that minimizes fuel use and emissions found in a typical aerial lift truck.

When at a job site, batteries can power all boom hydraulic functions and the climate control system for a full work day, without the use of the diesel engine. This means reduced noise from engine idle and elimination of any emissions while in battery mode. The hybrid bucket truck has a stock diesel engine and stock transmission.

The batteries require an eight-hour charge time. When the truck returns to the garage at the end of a work day, it is plugged into a three-phase, 240-volt outlet. The batteries recharge during off-peak hours using lower-cost electricity. The system can also be recharged at any point with the conventional diesel engine. The system provides the fuel efficiency and emission enhancements typical of a hybrid vehicle, while the truck is traveling to and from the work site.

Fuel cost estimates for the new hybrid bucket truck are half those of a non-hybrid truck. The ability to recharge the batteries at off-peak times offers significant savings.

In addition to the hybrid features of the PHEV bucket truck, the bucket can be lifted two extra feet after the boom is in place; it has a 55-foot vertical bucket reach, a 36-foot horizontal bucket reach and a 12-foot telescopic extension on the upper boom; the bucket can rotate around the boom 90 degrees; and the jib can lift 1,000 pounds. The total payload of the vehicle is 7,500 pounds.


      

Sponsored Recommendations

Snap-on Training: ADAS Level 2 - Component Testing

The second video for Snap-on's comprehensive overview of Advanced Driver Assistance Systems (ADAS), covering the fundamental concepts and functionalities essential for automotive...

Snap-on Training: Intro to ADAS

Snap-on's training video provides a comprehensive overview of Advanced Driver Assistance Systems (ADAS), covering the fundamental concepts and functionalities essential for automotive...

Snap-on Training: Guided Component Tests Level 2

The second video for Snap-on's comprehensive overview of Guided Component Tests, covering the fundamental concepts essential for diagnostic procedures.

Snap-on Training: Data Bus Testing and Diagnosis Part 1

Learn the basics of vehicle data buses and their diagnosis with Snap-on's Jason Gabrenas.

Voice Your Opinion!

To join the conversation, and become an exclusive member of Vehicle Service Pros, create an account today!